Commercial Heating Equipment — Maintenance Procedures For Industrial Systems
Modern HVAC equipment should be serviced at the end of the winter. By performing standard maintenance tasks, your HVAC system will be ready for use when the temperature begins to plunge during the months of autumn.
The Cabinetry And The Coil
Your HVAC unit may contain cabinetry that protects the interior components of the unit. Inspect the cabinetry for signs of damage. Make sure that all of the hardware that is used to secure the cabinet pieces are tight. The cabinetry may feature a door that leads to the heating coil. The heating coil (heating element) transfers heat.
The coil's surface needs to remain clean and dry. A clean, dry coil will operate efficiently. If you notice dust on the surface of the coil, a soft-bristled brush can be used to loosen the dirty residue. A vacuum attachment can be used to suck up loose dust.
The commercial HVAC equipment should be turned off when you are cleaning it. The coil becomes hot to the touch when a furnace is on. If you were to touch the coil while the commercial heater was running, you could endure a serious injury.
The Drain Pan
Some HVAC systems require the use of a drain pan. The pan is responsible for collecting condensation. Inspecting and cleaning the drain pan will involve emptying any moisture that has accumulated and wiping out the interior surface of the pan.
The manufacturer of your commercial heating equipment will specify the location of the drain pan. A diagram of the drain pan may be included in the owner's manual of your HVAC equipment.
The Fan Motor And The Blades
The parts that comprise the fan motor and blades may be made of metal. These metal materials will need to remain well-lubricated. Failing to lubricate the metal materials could result in excessive friction. Excessive friction could cause damage to the metal. It could also cause the metal to heat up to high temperatures.
A lubricant that is designed for use with your heating system should be applied to the metal. Before lubricating the metal, remove the cover that is concealing the fan motor and blades. Next, assess the metal surfaces for dust and loose debris.
Clean the surface of the motor and blades if necessary. A spray lubricant can be administered directly on each metal surface. A grease lubricant will need to be brushed or wiped across metal surfaces. Once you have finished, replace the cover over the fan motor and blades. For more information, visit a site like http://www.mercurytecinc.com.